RVMIC5 V2: How To Set Up A Condenser Mic

Introduction

The Rockville RVMIC5 V2 microphone stand is an excellent choice for both live performances using dynamic microphones and recording sessions with condenser microphones. In this guide, we’ll show you how to set up a condenser microphone on the RVMIC5 V2 stand, as well as how to use a pop filter to improve the quality of your recordings. This setup is perfect for capturing crisp, clear audio while minimizing unwanted noise from plosives like P’s and T’s.

Step-by-Step Instructions

Step 1: Attach the Shock Mount to the Mic Stand

1. Select the Right Threading:
   • The top of the boom arm has 5/8” threading, which fits most standard shock mounts. If your shock mount has 3/8” threading, simply unscrew the 5/8” threading to reveal the 3/8” threading beneath it.
2. Attach the Shock Mount:
   • Line up the threading at the bottom of the shock mount with the threading on top of the boom arm.
   • Screw it on securely until it's firmly attached.

Step 2: Adjust the Angle of the Shock Mount

1. Loosen the Adjustment Knob:
   • Locate the knob on the shock mount.
   • Loosen the knob to allow for adjustments.
2. Set the Desired Angle:
   • Adjust the angle of the shock mount to the ideal position for your microphone.
   • Once the desired angle is set, tighten the knob to lock the shock mount in place.

Step 3: Attach the Condenser Microphone

1. Place the Microphone in the Shock Mount:
   • Squeeze the clamps of the shock mount to open it.
   • Place your condenser microphone inside the mount and release the clamps to secure it.

Step 4: Attach the Pop Filter (Optional, but Recommended)

1. Loosen the Clamp:
   • To attach the pop filter, loosen the clamp at the bottom of the filter.
2. Position the Pop Filter:
   • Place the pop filter on the mic stand, ensuring it’s close enough to the microphone to catch plosive sounds like P’s, T’s, and K’s.
   • For this setup, position it near the top of the boom arm.
3. Tighten the Clamp:
   • Once positioned, tighten the clamp to secure the pop filter in place.

Step 5: Organize the Microphone Cable

1. Use the Cable Clips:
   • The RVMIC5 V2 comes with built-in cable management clips to keep your mic cable neat and tidy.
   • Run your microphone cable along the stand, and use the clips to secure the cable at the top and bottom of the stand for organization.

Conclusion

Setting up your condenser microphone with the Rockville RVMIC5 V2 is easy and will significantly improve the quality of your recordings. The shock mount helps reduce vibrations, while the pop filter eliminates unwanted plosives for clearer audio. The cable management clips ensure a neat setup, keeping your microphone cable organized.