RF WEDGE: How To Set Up & Use Two Remotes

Introduction

This guide will show you how to use two separate remotes to control different groups of RF Wedge PAR lights. This setup allows you to assign each remote to a specific group of lights for independent control or switch between groups using a single remote. The process is simple and requires only a few steps.

Step-by-Step Instructions

1. Set the Lights to RF Mode

• Power on each RF Wedge PAR light.
• Navigate to the RF Mode setting using the onboard controls.

2. Assign Lights to Different Remote Groups

• For the first group of lights, set them to Rem1.
• For the second group of lights, set them to Rem2.

3. Pair a Remote with a Specific Group

• By default, the remote controls any light assigned to Rem1.
• To switch a remote to control Rem2:
  1. Hold down the Up and Down buttons on the remote for a few seconds.
  2. Once switched, the remote will now control lights set to Rem2.
• Repeat this process for another remote if you want to control Rem1 separately.

4. Control Both Groups with One Remote (Optional)

• If you prefer to use a single remote for both groups:
  1. Set the remote to Rem1 and control the first group.
  2. Hold the Up and Down buttons to switch to Rem2.
  3. Control the second group without needing a second remote.

This method allows you to manage multiple lighting setups without the need for multiple remotes.

Conclusion

Setting up multiple remotes to control different groups of RF Wedge PAR lights is quick and easy. Whether you want independent control over each group or the flexibility to switch between them using a single remote, this method ensures a smooth lighting experience.