RF WEDGE: How To Set Up Wireless DMX

Introduction

This guide will walk you through the process of setting up a DMX controller to control multiple RF Wedge PAR Lights in a stage production, live venue, or DJ setup. You can connect your lights wirelessly or via DMX cables for full lighting control.

Step-by-Step Setup

1. Choose a DMX Channel Mode

The RF Wedge PAR lights offer two DMX modes:

• 6-Channel Mode: Basic control over color selection.
• 10-Channel Mode: Advanced control over colors and additional effects.

For this demonstration, we’ll use 10-Channel Mode.

2. Wireless DMX Setup

A. Set the Lights to Slave Mode

• Use the menu settings or the red switch on the light to set it to Slave Mode.
• The display should confirm it has switched to Slave Mode.

B. Assign the DMX Channel Mode

• Press Enter on the light and switch to 10-Channel Mode.

C. Sync the Lights to the DMX Controller

1. Set the DMX Code:
   • Press the DMX Code button on the light.
   • Select one of the seven available colors (this acts as a pairing code).
   • Choose the same color on your DMX controller.
   • The DMX Code button will flash on the controller, while the lights’ DMX code LED will remain solid.
2. Activate Scanner 1 on your DMX controller.

3. DMX Fader Controls in 10-Channel Mode

Once your DMX controller is connected, you can adjust the following settings using the faders:

• Example: If you select Color Cycle Mode (Fader 9, Value 51-89), you can use Fader 10 to adjust the speed.

4. Wired DMX Setup (Using DMX Cables)

If wireless DMX is unavailable, you can manually link your lights to the DMX controller using DMX cables.

A. Connecting the DMX Controller to Your Lights

1. Take a DMX cable and plug the male end into the DMX Out of the controller.
2. Plug the other end into the DMX In on the first light.

B. Connecting Additional Lights

1. Take another DMX cable.
2. Plug the male end into the DMX Out of the first light.
3. Plug the other end into the DMX In on the second light.
4. Repeat for all additional lights in your setup.

C. Activating DMX Control

• The lights automatically lock into Slave Mode when connected via DMX cables.
• Select 6-Channel or 10-Channel Mode on each light.
• Activate Scanner 1 on your DMX controller.
• Test the lights by adjusting Fader 1 (Master Dimmer).

Conclusion

Setting up a DMX controller for your RF Wedge PAR Lights is quick and easy, whether using wireless DMX or DMX cables. This setup allows full control over colors, effects, and brightness, making it perfect for stage productions, DJ performances, and event lighting.