PIXEL HYBRID PACK: How To Charge

Introduction

Charging your Rockville Pixel Hybrid Bar Pack is a simple process. This guide will walk you through the steps to ensure that your lights are properly connected and charging efficiently.

What You Need

• The included power cables for each light
• The main power cable for the case

Step-by-Step Charging Instructions

1. Connecting the Lights to the Charging Case

1. Locate the power outlets on the side of the case.
2. Take a power cable and plug the blue end into the Power In socket of each light.
3. Plug the other end of each cable into one of the power outlets on the case.

2. Connecting the Charging Case to Power

1. Find the IEC power socket on the outside of the case.
2. Plug the IEC end of the main power cable into this socket.
3. Plug the other end of the power cable into a wall outlet or other power source.

3. Turning on Charging Mode

1. Flip the power switch on the case to the "On" position.
2. The lights will begin charging.

4. Checking Battery Life

• If the lights are completely drained, they take about 6 hours to fully charge.
• To check the battery level on each light, turn it on and look at the battery life indicator on the top.

5. Ventilation Reminder

• Keep the case open while charging to allow for proper ventilation and prevent overheating.

Conclusion

Charging your Pixel Hybrid Bar Pack is straightforward with the included power cables and case. By following these steps, you can ensure your lights are always ready for use.