PIXEL HYBRID PACK: How To Mount & Position

Introduction

Setting up your Rockville Pixel Hybrid Bar Pack lights is simple, whether you're using them for wall washing, DJ facades, or mounting them onto a truss. This guide will walk you through the different positioning methods and adjustments.

Adjusting the Light's Angle

Each light in the pack comes with adjustable feet that allow you to change the angle for different applications.

Steps to Adjust the Angle:

1. Locate the adjustable feet on both sides of the light.
2. Find the knobs on each side of the feet.
3. Loosen the knobs to adjust the angle.
4. Tilt the light to your desired position.
5. Tighten the knobs to lock the position in place.

Setting Up the Light for Different Applications

1. Floor Placement for Wall Washing

You can use the Pixel Hybrid Bar Pack for wall washing in two ways:

• Flush Against the Wall – Place the light straight up for a direct wash effect.
• Angled Away from the Wall – Position the light a few inches away and tilt it using the adjustable feet to create a wider wash effect.

These same methods can also be used to light up a DJ facade.

2. Mounting the Light to a Truss

To mount your light onto a truss, you’ll need two LC70 lighting clamps (or similar truss clamps).

Steps to Mount the Light:

1. Remove the wing nut from the clamp.
2. Unscrew the bolt at the bottom of the clamp.
3. Align the clamp’s hole with the mounting hole on the foot of the light.
4. Insert the bolt through both holes and tighten it.
5. Reattach the wing nut for extra security.
6. Repeat these steps for the second clamp on the other foot.

Attaching the Light to the Truss:

1. Loosen the butterfly screws on each clamp.
2. Line up the clamps with an open spot on the truss.
3. Secure the light by tightening the butterfly screws.

Even after mounting the light on a truss, you can still adjust the angle using the knobs on each side of the feet.

Conclusion

The Pixel Hybrid Bar Pack offers flexible positioning options for any setup. Whether placed on the floor for wall washing, angled for DJ facades, or mounted on a truss, the adjustable feet and clamps make installation easy.