PIXEL HYBRID PACK: How To Use The Remotes

Introduction

This guide will walk you through how to use the wireless remote control with your Rockville Pixel Hybrid Bar Pack. The remote allows you to control various settings, including brightness, color, speed, and mode selection. These steps apply to all the lights and remotes included in the pack.

Step-by-Step Instructions

1. Powering the LEDs On and Off

• Press the On button to turn on the LEDs inside the light.
• Press the Off button to turn off the LEDs. (Note: This does not power off the light entirely; it only controls the LEDs.)

2. Adjusting Brightness

• Press Brightness Up to increase the brightness.
• Press Brightness Down to dim the light.

3. Selecting Lighting Modes

The remote allows you to switch between different lighting modes:

• Strobe Mode – Creates a flashing strobe effect.
• Auto Mode – Runs through a pre-programmed light sequence.
• Fade Mode – Smoothly transitions between colors.
• Pulse Mode – Lights gradually turn on and off.
• Static Mode – Selects a single static color.

4. Changing Static Colors

• If the light is set to Static Mode, use the Color Wheel Up and Color Wheel Down buttons to cycle through different colors.

5. Adjusting Speed for Light Transitions

• Press Speed Up to make transitions faster.
• Press Speed Down to slow them down. (This applies to Auto, Fade, Pulse, and other animated modes.)

6. Controlling DMX Settings

If you are using a DMX controller, you can adjust settings without accessing the back panel:

• Press DMX Address to change the DMX address.
• Use Mode Up or Mode Down to cycle through DMX addresses.
• Press DMX Channel to change the channel assignment.

7. Selecting Sound Modes

The light has four different sound-activated modes that react to music:

• Press Sound Mode 1, 2, 3, or 4 to select the desired sound mode.
• Adjust the microphone sensitivity using Sensitivity Up or Sensitivity Down to control how the light responds to sound.

8. Activating Multicolor and Single Color Effects

• Press Multicolor for a rainbow cycling effect.
• Use Color Wheel Up/Down to adjust the cycling pattern.
• Choose from four preset colors: Red, Green, Blue, or Purple.
• Adjust the shade of the selected color with Color Wheel Up/Down.

9. Troubleshooting: Remote Not Working?

If your remote is not controlling the light, check the IRCL setting on the light:

1. Press the Menu button on the light until you see the IRCL option.
2. Press Enter and use the Up/Down buttons to change the setting from Off to On.
3. The remote should now work properly.

Conclusion

The wireless remote for the Rockville Pixel Hybrid Bar Pack makes it easy to adjust lighting settings on the fly. Whether you’re controlling brightness, selecting colors, or syncing with music, the remote provides full control over your light show.