TITAN MIX12A: How To Set Up w/ A Mixer

Introduction:

In this guide, we’ll show you how to connect your mixer to the Rockville TITAN MIX12A speakers. Whether you're using a mixer with quarter-inch or XLR outputs, this process is straightforward. You’ll learn how to properly set the inputs and adjust the settings for optimal sound output.

Requirements:

• Rockville TITAN MIX12A Speakers
• 1/4" (Quarter-Inch) or XLR cables
• Any Mixer with 1/4" or XLR Line Outputs (e.g., RockMix 8, RockMix 10FX)

Step-by-Step Instructions:

Stereo / Two Speaker Setup

Step 1: Set the Channels to Line Mode

• Since the mixer sends out a line-level signal...
  The selector switch/button should be set to Line on the channel you're connecting it into on each TITAN MIX12A speaker.
• To do this, find the button above the input that you're using on the TITAN MIX12A.
• Press the button to switch it to line mode for each channel.

Step 2: Connect the Mixer to the Speakers

• Take two quarter-inch or XLR cables. (Quarter-inch to XLR cables can also be used.)
• Plug one end of each cable into the main outputs (or other line outputs; e.g. monitor, aux) on your mixer.
• Plug the other end of each cable into the previously selected channel on each of your TITAN MIX12A speakers.

Mono / Single Speaker Setup

Step 1: Deactivate Bluetooth on Channel 5/6

• To do this, find the BT/TWS Button button above the Channel 5/6 Volume knob.
• Make sure the BT/TWS Button on Channel 5/6 is not pressed in.

Step 2: Connect the Mixer to the Speaker

• Take two quarter-inch cables. (Quarter-inch to XLR-female cables can also be used.)
• Plug one end of each cable into the main outputs (or other line outputs; e.g. monitor, aux) on your mixer.
• Plug the other end of the cables into Channel 5/6 your TITAN MIX12A speakers.

Troubleshooting & FAQs:

• Q: My mixer isn't producing any sound. What should I check?
  • A: Make sure the cables are securely plugged into both the mixer and the TITAN MIX12A speakers. On the mixer, check that that all necessary input channels and outputs are not muted and turned up (or active, depending on mixer).
• Q: What is the purpose of setting the channels to Line mode?
  • A: The Line mode setting ensures that the speakers receive the correct type of signal from the mixer, which is a line-level signal.
• Q: How do I expand my setup with more speakers or subwoofers?
  • A: You can repeat the process connecting additional speakers using the same procedure. For each new speaker, you can use another line output (if available) from your mixer. You can also use the XLR Mix Output to connect an additional speaker or subwoofer to any of your TITAN MIX12A speakers to expand your setup.

Conclusion:

You have now set up your mixer with the Rockville TITAN MIX12A speakers. By following these steps, you can ensure a smooth connection for optimal sound performance. Adjust your mixer and speaker settings for the best audio output.