TITAN MIX12A: How To Set Up a Mic / Instrument

Introduction:

This guide will help you connect your microphone and instrument to the Rockville TITAN MIX12A. Whether you’re setting up a microphone for vocals or plugging in an instrument, this step-by-step process will ensure a smooth setup. We’ll also cover how to adjust the settings for optimal sound, including using the three-band EQ to fine-tune your audio.

Requirements:

• Rockville TITAN MIX12A
• Dynamic Microphone
• XLR cable
• Instrument (optional)

Step-by-Step Instructions:

A.) Set Up the Microphone

1. Take your dynamic microphone and XLR cable.
2. Plug the female end of the XLR cable into the microphone.
3. Plug the male end of the XLR cable into any channel from 1 to 4 on the TITAN MIX12A.
4. Once the microphone is connected, locate the button above the input on the channel.
5. Switch the button from Line to Microphone mode by pressing it in. This activates microphone mode for that channel.

B) Adjust the Volume

1. Raise the volume knob on each channel you're using to your desired level.
2. Adjust the Master Volume knob on the mixer to ensure everything is at an audible level.
3. You can also adjust the Sub Level knob for additional sound control.

C) Test the Microphone

1. Turn on your microphone (if using wireless, or other mic with a switch) and make sure the Master Volume knob is turned up to perform a sound check. 
2. Speak into the mic (e.g., “Check one, two”), while slowly increasing the Channel Volume knob to ensure that the audio is coming through the speakers at a good volume.
3. Adjust the Channel Volume, EQ and Master Volume knobs as necessary to fine-tune the sound.

D.) Adjust the Three-Band EQ (Optional)

1. The three-band EQ allows you to adjust the bass, midrange, and treble frequencies of your microphone sound.
2. Use the EQ knobs to customize the sound of your voice or instrument to your liking.

E.) Set Up the Instrument (Optional)

1. For a Guitar: Choose any available channel from 1 to 4 on the TITAN MIX12A and make sure the selector switch is set to Mic/Guitar (pressed in).
2. Connect the quarter-inch output from the guitar using your previously selected channel on the TITAN MIX12A.
3. For a Keyboard (or other stereo electronic instrument): Make sure the BT/TWS Button on Channel 5/6 is not pressed in; deactivating Bluetooth.
4. You can connect the left and right quarter-inch output from the keyboard (or other stereo electronic instrument) using Channel 5/6 on the TITAN MIX12A

F.) Adjust the Volume

1. Raise the volume knob on each channel you're using to your desired level.
2. Adjust the Master Volume knob on the mixer to ensure everything is at an audible level.
3. You can also adjust the Sub Level knob for additional sound control.

Troubleshooting & FAQs:

• Q: I don’t hear any sound from the microphone. What should I check?
  • A: Ensure that the microphone is plugged into the correct channel, and make sure the microphone mode button is pressed in. Also, check the settings on both the Channel Volume and Master Volume knobs.
• Q: How do I adjust the sound of my microphone?
  • A: Use the three-band EQ to adjust the bass, midrange, and treble frequencies. This will help you fine-tune your microphone’s sound to better fit the acoustics of the room or your desired audio quality.
• Q: Why is my mic or instrument is not coming through?
  • A: Double-check that the correct mode (mic/instrument mode) is selected for the relevant channel.

Conclusion:

You’ve now set up your microphone (and instrument, if needed) with the TITAN MIX12A. With simple volume controls and the three-band EQ, you can fine-tune your performance to achieve the best sound. Enjoy your performance!