TITAN MIX12A: How To Assemble and Dissemble

Introduction:

In this guide, we’ll walk you through the process of assembling and packing your Rockville TITAN MIX12A speaker system. Whether you’re setting it up for a performance or packing it away after use, this step-by-step tutorial will help you understand the components and how to handle them efficiently.

Requirements:

• Rockville TITAN MIX12A System (Subwoofer, Speaker Array Columns, AC PowerCon Cable)

Step-by-Step Instructions:

A.) Unpack the Components

Start by carefully removing and laying out (for easy access) all the components from the packaging:

• 12" Amplified Subwoofer
• Lower 4-Speaker Array Column
• Upper 8-Speaker Array Column
• 8-Foot PowerCon Cable
• Carrying Bag for Easy Transport
• Cover for the Subwoofer

B.) Identify the Parts

1. Lower 4-Speaker Array Column: The spacing section has a port on the top and a connector piece on the bottom. It is also longer than the array.
2. Upper 8-Speaker Array Column: The array is the main speaker unit, and it only has a connector on the bottom.
3. The Lower 4-Speaker Array Column will always be longer than the Upper 8-Speaker Array Column, which is an easy way to differentiate the two pieces.

C.) Prepare the Subwoofer

1. Remove the cover from the subwoofer.
2. On top of the subwoofer, you’ll find a port where the Lower Array Column Section will connect.

D.) Attach the Lower Array Column to the Subwoofer

1. Take the Lower Array Column Section and line up the connector on the bottom with the port on top of the subwoofer.
2. Insert the Lower Array Column Section into the port on the subwoofer, ensuring it is securely in place.

E.) Attach the Upper Array Column to the Lower Array Column

1. Take the Upper Array Column Section and line up the connector on the bottom of the array with the top of the Lower Array Column Section.
2. Insert the Array Speaker into the Lower Array Column Section, making sure it is securely connected.

Your TITAN MIX12A is now fully assembled and ready for use!

Troubleshooting & FAQs:

• Q: How can I tell the difference between the array and the spacing section?
  • A: The spacing section is longer and has a port on top, while the array only has a connector on the bottom and is shorter in length.
• Q: The connector isn’t fitting properly. What should I do?
  • A: Double-check that the connectors are aligned properly before inserting. Ensure you're using the correct piece (Lower vs. Upper Array Column Section) in the proper position.
• Q: The PowerCon cable doesn’t seem to connect properly. What should I do?
  • A: Ensure the grooves on the cable align properly with the grooves inside the PowerCon port. Once aligned, twist the cable to the right until it clicks into place.
• Q: How do I pack the system away?
  • A: Simply reverse the steps of assembly. Disconnect the power con cable, remove the array speaker from the section, and remove the section from the subwoofer. Then pack all components back into the bag.

Conclusion:

You’ve now successfully assembled your Rockville TITAN MIX12A system! By following these steps, you can ensure a quick and easy setup for your next event. For packing it away, simply reverse the steps to disconnect and store the components safely.